honeywell pro 3000 access control installation manual

Heat (1st stage) 20-30 Vac Running Current 0.02-1.0 A

Set the System switch to Cool, and set the temperature level below the current room temperature.

Set the System switch to Heat, and set the temperature level above the current room temperature.

Wait 5 minutes for the system to restart safely, without damage to the compressor.

Compressor protection feature is engaged.

Make sure heating and cooling temperatures are set to

Wait 5 minutes for the system to respond.

Make sure the temperature is set lower than the Inside temperature. Make sure the temperature is set higher than the Inside temperature. Heating or cooling system does not respond

Make sure fresh AA alkaline batteries are correctly installed (see page 2).

Make sure furnace door is closed securely.

Make sure power switch at heating & cooling system is on.

Check circuit breaker and reset if necessary.

Most problems can be corrected quickly and easily. If you have difficulty with your thermostat, please try the following suggestions. Honeywell PRO 3000 Series Troubleshooting

Press and hold UP DOWN to exit and save settings.

To begin, press and hold the UP and DOWN buttons until the display changes. (This setting is for systems that allow the thermostat to control the fan in a call for heat, if a fan wire is connected to the G terminal.)įollow the procedure below to configure the thermostat to match the installed heating/cooling system, and customize feature operation as desired. (This setting is for systems that control the fan in a call for heat.)Įlectric or Heat Pump: Change the switch to this setting for heat pump or electric heat systems. Gas or Oil: For gas or oil heating systems, leave the fan operation switch in this factory-set position.

Place wallplate over anchors, insert and tighten mounting screws.

Drill holes at marked positions as shown below, then tap in supplied wall anchors.

Position wallplate on wall, level and mark hole positions with pencil.

Remove the wallplate from the thermostat by pulling from the bottom, then follow directions below for mounting. Honeywell PRO 3000 Series installation Manual Wallplate installation

Honeywell pro 3000 access control installation manual